A patented, simple yet effective tight seal for voids formed in a concrete wall by the removal of a taper tie rod or pass through tie sleeve, or tube bushing.
This is a very easy to use product: all you have to do is put the piece in a riveter and rivet it into the hole, that’s it!
Insert Rivestop into the riveter.
Position Rivestop flush with the hole to be sealed.
Action the riveter until the rivet pins are cut.
FREQUENTLY ASKED QUESTIONS
Rivestop is a mechanical system created to seal formwork holes quickly and effectively.
Because of its advantages: Our product is very easy to apply, it seals the hole tightly, and it saves a lot of time in the sealing process.
Rivestop is an elastic rivet that expands inside the hole by approximately 50% of its original diameter, exerting force against the walls that the hole is in, thus sealing it completely.
No, Rivestop’s seal does not depend on the person who applies it; it always seals with uniform force, so that’s a variable that our system eliminates.
Yes. It’s very easy to use; all you have to do is put the piece in the riveter and rivet it into the hole. That’s all there is to it.
Once the Rivestop is riveted into the hole that needs to be sealed, it’s sealed. There are only two possibilities: it’s in place (riveted) or it isn’t; in other words, there’s no way to do it half-right or half-wrong: it either is or isn’t in place.
You can place it on either side.
No, it’s not necessary. The hole is sealed from the Rivestop installation, though you can apply mortar if you want or if engineering specifications require it.
Yes, it can be applied in wet conditions; even if water is coming out of the hole, Rivestop can still be applied.
No, it’s cannot be removed once it has been installed. Rivestop installation is irreversible and it can only be taken out by boring into the wall.
No, you don’t need any special tools, just a standard riveter.
It can be used on all types of holes, whether they’re cone-shaped or cylinder-shaped, since it doesn’t need to be attached to the wall with the hole in order to be installed; it expands once you put it in with the riveter with no need for other support
The riveting action takes approximately 3-5 seconds. As we’ve stated previously, installing it is very easy and doesn’t depend on the skill of the person putting it in; it works very quickly. The time savings compared to other systems are truly impressive.
Yes, it has been tested. Our product bears the EC seal and has been approved by the European Organization for Technical Approvals (EOTA).
A plug is something is only useful for plugging something, such as a cork, a rubber stopper, a plastic stopper, etc… Rivestop is a mechanical system that completely seals the formwork hole permanently and never slips out.
Garages, basements, elevators, buildings, pools, warehouses, sewage systems, etc.